KidKraft Grand Valley Retreat Installation And Operating Instructions Manual page 102

Step 46: Attach TNR2 Slide Exit to Exit Elbow Assembly
A: Insert flange of Exit Elbow Assembly (slide elbow) into the slots on TNR2 Slide Exit. (fig. 46.1)
B: Rotate Slide Exit and use Quadrex Driver as a guide pin so the holes are aligned and attach with 5 (PB1) 1/4
x 3/4" Pan Bolts (with lock nuts) starting with the bottom middle hole and working up each side. (fig. 46.2 and
46.3)
C: At this point make sure all the slide bolts are tight. Use a 7/16" open end wrench to hold nut and then
tighten bolt with Quadrex Driver on Clamp Rings.
Fig. 46.1
TNR2
Slide Exit
Exit Elbow
Assembly
Slot of TNR2
Slide Exit
Lock
Nut
Fig. 46.2
PB1
Lock
Nut
Start with
this bolt
Hardware
5 x 1/4 x 3/4" Pan Bolt
PB1
(1/4" lock nut)
102
PB1 Bottom of Slide Views
1 x TNR2 Slide Exit
Fig. 46.3
PB1
Other Parts