Advertisement
Step 33: Attach Access Ladder Rockwall Assembly
Pre-drill all holes using a 1/8" drill bit before installing the Wafer Lags
A: Remove (030) Board Access from the Access Ladder Rockwall, previously assembled in Step 3. Set the
board and screws aside, they will be re-attached. (fig. 33.2)
B: Place the Access Ladder Rockwall on the Back side of the fort and attach to (073) Back Floor with 1
(WL3) 1/4 x 1-3/8" Wafer Lag Screw (with flat washer) in each Swing Bracket. (fig. 33.1, 33.2 and 33.3).
C: Re-attach (030) Board Access to the same place it was removed. (fig. 33.2)
Fig. 33.3
Swing
Bracket
Fig. 33.2
073
073
1/4" Flat
Washer
WL3
Hardware
3 x
1/4 x 1-3/8" Wafer Lag
WL3
(1/4" flat washer)
86
Fig. 33.1
Back
Important. Flush
to Floor Boards
030
Advertisement
