Advertisement
Step 28: Swing Post Assembly
Part 2
D: Attach KidKraft plaque to centre of (260) Engineered SW Beam
(over top of t-nut) using 4 (S18) #6 x 1" Wood Screws. (fig. 28.6)
E: Place (260) Engineered SW Beam on Heavy T-Bracket and
attach to fort with 1 (G17) 3/8 x 6" Hex Bolt (with 2 flat washers,
plastic formed washer and lock nut) and 1 (G18) 3/8 x 9" Hex Bolt
(with 2 flat washers, plastic formed washer and lock nut) as shown
in fig. 28.7 and 28.8.
F: Place (260) Engineered SW Beam (end without Wafer Bolt from
Step 27) in between Heavy L-Brackets assembled in Step A making
sure holes are lined up then attach Swing Post Assembly to Swing
Beam Assembly using 1 (G20) 3/8 x 4" Hex Bolt (with 2 flat washers
and lock nut) through Heavy L-Bracket. (fig. 28.9)
G: Attach (260) Engineered SW Beam to Heavy G-Bracket with 1
(G17) 3/8 x 6" Hex Bolt (with 2 flat washers, plastic formed washer
and lock nut). (fig. 28.9)
Fig. 28.6
Front View
KidKraft
Plaque
Heavy L-Bracket
Fig. 28.9
Heavy G-Bracket
3/8" Lock
Nut
4 x
#6 x 1" Wood Screw
S18
1 x
3/8 x 4" Hex Bolt
G20
(3/8" flat washer x 2 & 3/8" lock nut)
x 4
S18
G20
3/8" Flat
Plastic
Washer
Formed
Washer
3/8" Flat
Washer
260
Hardware
2 x
3/8 x 6" Hex Bolt
G17
(3/8" flat washer x 2, plastic formed washer & 3/8" lock nut)
1 x
3/8 x 9" Hex Bolt
G18
(3/8" flat washer x 2, plastic formed washer & 3/8" lock nut)
Fig. 28.7
KidKraft Plaque
in back of beam
Fig. 28.8
G17
Plastic
Formed
Washer
260
G17
3/8" Flat
Washer
81
Back
3/8" Lock
Nut
Other Parts
1 x KidKraft Plaque
G18
Heavy
T-Bracket
3/8" Flat
Washer
Advertisement
