Advertisement
Tools Required
Shovel
Measuring
Tape
Part Identification Key
On each page, you will find the parts and
quantities required to complete the assembly
step illustrated on that page. Here is a sample.
Symbols
Throughout these instructions symbols are provided as important reminders for proper and safe assembly.
This identifies information that requires special
attention. Improper assembly could lead to an
unsafe or dangerous condition.
Use
Use
Help
Help
Measure
Check that assembly is square
Distance
before tightening bolts.
Use a measuring tape to assure
proper location.
CAUTION – Protrusion Hazard
Once the assembly is tightened, watch for exposed
threads. If a thread protrudes from the T-Nut, remove the
bolt and add washers to eliminate this condition. Extra
washers have been provided for this purpose.
Proper Hardware Assembly
Lag screws require drilling pilot
holes to avoid splitting wood. Only
a flat washer is required. For ease of
installation liquid soap can be used
on all lag-type screws.
For bolts, tap T-Nut into hole with
hammer. Insert the hex bolt through
lock washer first then flat washer then
hole. Because the assemblies need to
be squared do not completely tighten
until instructed. Pay close attention to
diameter of the bolts. 5/16" is slightly
larger than 1/4".
Keys to Assembly Success
Drill (1/8"
Safety
3/16" Bit)
Glasses
Where this is shown, 2 or 3
people are required to safely
complete the step. To avoid
injury or damage to the
assembly make sure to get help!
Square
Assembly
Hammer
Ratchet 1/2",
7/16" & 9/16"
123
2X
1234
Post 2 x 4 x 83"
Check that set or assembly is properly level
before proceeding.
Pre-drill
1/8" Bit
Pre-drill a pilot hole before
fastening screw or lag to prevent
splitting of wood.
This indicates time to tighten bolts, but
not too tight! Do not crush the wood.
This may create splinters and cause
structural damage.
No
6
6
Level
#2 & #3 Phillips
Square
or Robertson
Step
Ruler
Ladder
Use
Level
Tighten
Bolts
Yes
Advertisement
