Advertisement
Step 48: Attach Ground Stake to SL Support
A: In the spot shown in fig. 48.1 drive 1 Rebar Ground Stake 13" into the ground against the (400) SL
Support. Be careful not to hit the washer while hammering stake into the ground as this could cause the
washer to break off.
B: Attach the ground stake to (400) SL Support using 1 (S7) #12 x 2" Pan Screw as shown in fig. 48.2.
C: After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth
any sharp edges from impact area and touch up with outdoor paint.
Fig. 48.2
13" In Ground
Warning! To prevent tipping and avoid potential
injury, stakes must be driven 13" into ground.
Digging or driving stakes can be dangerous if you
do not check first for under-ground wiring, cables
400
S7
Rebar
Ground
Stake
1 x
S7
or gas lines.
Hardware
#12 x 2" Pan Screw
104
Fig. 48.1
Other Parts
1 x Rebar Ground Stakes
Advertisement
