KidKraft Grand Valley Retreat Installation And Operating Instructions Manual page 44

Step 11: Swing Wall Assembly
Part 2
C: Pre-drill pilot holes with a 3/16" drill bit then attach (111) Diagonal flush to outside edge of (050) Narrow
Window Panel and (051) SL Window Side Panel with 1 (WL5) 1/4 x 2-1/2" Wafer Lag (with flat washer) per
diagonal. (fig. 11.4)
D: Tighten all 6 (G8) 5/16 x 2" Hex Bolts from Step 11 A and B.
E: In the opening of (043) SW Side Panel attach (112) SW Table Top, tight to the corner of the panels, with 3
(S4) #8 x 3" Wood Screws as shown in fig. 11.4.
Fig. 11.4
WL5
Wood Parts
1 x SW Table Top FSC 5/4 x 3 x 31-3/4"
112
Flush
Tight
111
051
S4
043
Hardware
2 x 1/4 x 2-1/2" Wafer Lag (1/4" flat washer)
WL5
3 x #8 x 3" Wood Screw
S4
44
050
WL5
Tight
112
1/4" Flat
Washer
111