Software Linkload Commands
Installing an NIU/SCM Release from Tape
This command is used to install an NIU or SCM release from tape to the RF-C! hard drive.
Note:
To move (position) the cursor on the screen, use the <tab> or down arrow <
down, <backspace> or up arrow <
the right arrow <
1.
From the Infrastructure Command Groups menu, use the
the left of the listing
Figure 6-1: Select Software LInkload
The NIU/SCM Software Linkload screen appears (see Figure 6-2).
6-2
↑
> to move up, left arrow <
→
> to move to the right.
and press:
Software Linkload
6880494G55-O
RF-Conductor! Controller NIU Remote Configuration
←
> to move to the left and
to position the cursor to
<tab>
(see Figure 6-1).
<Return>
↓
> to move
May 1998