Table of Contents
Advertisement
Alignment Commands
4.
The Set GPS Offset screen appears (see Figure 3-9).
5.
Enter the GPS Offset and press
0-450000 in microseconds.
Note:
Use the delay values from the maintenance data only. Do not vary the value by large numbers
unless reported by the maintenance report. Suspend the system to avoid losing pages.
6.
To return to the previous menu or screen, press:
Figure 3-9: Set GPS Offset Screen
3-10
RF-Conductor! Controller NIU Remote Configuration
to execute the command. The valid range is
<ctrl + e>
<Ctrl + p>.
6880494G55-O
May 1998
Advertisement
Table of Contents
