Infrastructure Command Group Parameters; Table 2-1: Infrastructure Command Group Menu Options - Motorola RF-Conductor! 3200 Manual

Infrastructure Commands Overview

Infrastructure Command Group Parameters

The Infrastructure Commands menu provides six options: Alignment, SuperStream,
Diagnostics, Software Linkload, Station, and Site Encoding (see Table 2-1).
Table 2-1: Infrastructure Command Group Menu Options (Sheet 1 of 2)
Menu Option
Alignment
SuperStream
Diagnostic
Software Linkload
2-4
RF-Conductor! Controller NIU Remote Configuration
Description
The Alignment command group contains the following options:
- Add Maintenance Group
- Delete Maintenance Group
- Change Alignment Type
- Set GPS Offset
- Set Link Path Delay
- Recalculate GPS
The SuperStream command group is used to change the specific
parameters that uniquely identify each transmitter. It has these options:
- Change Zone Map
- Change Device ID
- Change Maintenance ID
- Change System ID
- Change Link Parameters
This command group provides diagnostic commands between the RF-C!
controller system and the transmitters. It includes the following menu
options:
- Set Auxiliary Outputs
- Reset Dial Modem
- Enable Modem Auto-Answer
- Change Password
- Set Date & Time
- Reset NIU Alarms
- Reset NIU ALarms/Log/Stats
- Reset NIU Log
- Reset NIU Stats
- Reset Transmitter
- Set BER Limit
- Set Failsafe Timeout
- Disable Paging
This command group provides NIU/SCM software linkload commands:
- Install a NIU/SCM release from tape
- Delete an Installed NIU/SCM Release
- Linkload an Installed NIU/SCM Release
- Send Bank Switch by Version command
6880494G55-O May 1998