Table of Contents
Advertisement
RF-Conductor! Controller NIU Remote Configuration
Disabling Paging
This command is used to disable or enable the keying of a transmitter.
Enabling the keying of the transmitter allows the transmitting of information from the base
station; disabling stops the keying of the transmitter.
1.
From the Diagnostic menu, use the
Disable Paging
Figure 5-22: Diagnostics Screen—Disable Paging
The Select Disable Paging screen appears (see Figure 5-23).
2.
Position the cursor to select Yes or No and press:
The Infrastructure Commands Group menu appears with a message
in the message bar of the screen.
accepted
3.
To return to a previous menu or screen, press:
May 1998
<tab>
and press:
(see Figure 5-22).
<Return>
6880494G55-O
to position the cursor to the left of the listing
.
<Return>
Command request
<Ctrl + p>.
Diagnostic Commands
5-23
Advertisement
Table of Contents
