Table of Contents
Advertisement
RF-Conductor! Controller NIU Remote Configuration
Changing a Device ID
The Device ID allows a unique identification number for each transmitter or a monitor
receiver controller.
Note:
This command can be executed only in device addressing mode for a single transmitter.
1.
From the SuperStream menu, use the
Change Device ID
Figure 4-4: SuperStream Menu—Change Device ID
The Change Device ID screen appears (see Figure 4-5).
2.
Enter the Device ID and press
The Infrastructure Commands Group menu appears with a message
in the message bar of the screen.
accepted
3.
To return to a previous menu or screen, press:
May 1998
<tab>
and press:
(see Figure 4-4).
<Return>
Valid values are 1-8191.
<Return>.
6880494G55-O
to position the cursor to the left of the listing
Command request
<Ctrl + p>.
SuperStream Commands
4-5
Advertisement
Table of Contents
