Diagnostic Commands
Setting Auxiliary Outputs
This command is used to set a transmitter's auxiliary outputs as active or inactive.
auxiliary output lines from the transmitter can be used to control other equipment at a
base transmitter site. For example, an output line can be used to turn on a cooling fan
at the base transmitter sit
Note:
To move (position) the cursor on the screen, use the <tab> or down arrow <
down, <backspace> or up arrow <
the right arrow <
1.
From the Infrastructure Command Groups menu, use the
the left of the listing
Figure 5-1: Diagnostic Menu
The Diagnostics screen appears (see Figure 5-2).
5-2
e
↑
> to move up, left arrow <
→
> to move to the right.
and press:
Diagnostics
6880494G55-O
RF-Conductor! Controller NIU Remote Configuration
←
> to move to the left and
to position the cursor to
<tab>
(see Figure 5-1).
<Return
The
↓
> to move
May 1998