Table of Contents
Advertisement
Alignment Commands
Adding a Maintenance Group
This command is used to add a maintenance ID to a monitor receiver controller.
Note:
To move (position) the cursor on the screen, use the <tab> or down arrow <
down, <backspace> or up arrow <
the right arrow <
1.
From the Alignment menu, use the
Add Maintenance Group
Figure 3-1: Alignment Menu—Add Maintenance Group
The Add Maintenance Group screen appears (see Figure 3-2).
3-2
↑
> to move up, left arrow <
→
> to move to the right.
to position the cursor to the left of the listing
<tab>
and press:
(see Figure 3-1).
<Return
6880494G55-O
RF-Conductor! Controller NIU Remote Configuration
←
> to move to the left and
↓
> to move
May 1998
Advertisement
Table of Contents
