Diagnostic Commands
Setting Failsafe Timeout
This command is used to set the failsafe timeout. The failsafe timeout value is used when
monitoring the status of the link, that is, the SuperStream stream. If the transmitter is not
receiving the SuperStream stream and the timer expires, the transmitter switches to the off-
line flash.
1.
From the Diagnostic menu, use the
Failsafe Timeout
Figure 5-19: Diagnostics Screen—Set Failsafe Timeout
The Select Failsafe Timeout screen appears (see Figure 5-20).
2.
To disable failsafe timeout, position the cursor by
Infrastructure Commands Group menu appears with a message
in the message bar of the screen.
accepted
5-20
<tab>
and press:
(see Figure 5-19).
<Return>
6880494G55-O
RF-Conductor! Controller NIU Remote Configuration
to position the cursor to the left of the listing
and press:
Disable
Set
. The
<Return>
Command request
May 1998