Sending Bank Switch By Version Command; Figure 6-9: Niu/Scm Software Linkload Screen-Send Bank Switch By Version - Motorola RF-Conductor! 3200 Manual

Software Linkload Commands

Sending Bank Switch by Version Command

This command is used to change the bank to the off-line flash in dual flash units. Bank switch
to the off-line flash will occur only if it has the given version. This command is ignored if a
link load is in progress. The NIU or SCM will go through a reset and then start executing from
the other flash.
1. From the NIU/SCM Software Linkload screen, use the
left of the listing
Figure 6-9).
Figure 6-9: NIU/SCM Software Linkload Screen—Send Bank Switch by Version Command
The Select Site Controller Type screen appears (see Figure 6-10).
6-10
Send Bank Switch by Version command
6880494G55-O
RF-Conductor! Controller NIU Remote Configuration
to position the cursor to the
<tab>
and press:
<Return>
(see
May 1998