SuperStream Commands
Introduction
The SuperStream parameters command group is used to change the specific parameters
which uniquely identify each transmitter.
1.
To access SuperStream commands, From the Infrastructure Command Groups menu, use
the
to position the cursor to the left of the listing
<tab>
(see Figure 4-1).
2.
The SuperStream menu appears. All procedures in this chapter are referenced from the
SuperStream menu.
Figure 4-1: Selecting SuperStream from the Infrastructure Command Groups Menu
4-2
RF-Conductor! Controller NIU Remote Configuration
6880494G55-O
and press:
SuperStream
<Return>
May 1998