Table of Contents
Advertisement
RF-Conductor! Controller NIU Remote Configuration
Setting FLEX/ReFLEX Polarity
This command is used to set the FLEX/ReFLEX polarity.
1.
From the Site Encoding screen, use the
Set FLEX/ReFLEX Polarity
Figure 7-8: Infrastructure Command Groups—Set FLEX/ReFLEX Polarity
The Select FLEX/ReFLEX data polarity screen appears (see Figure 7-9):
2.
To select normal, use the
<Return>.
The Site Encoding screen appears with a message
message bar.
May 1998
and press:
to position the cursor to the left of the listing and press:
<tab>
Normal is the default setting.
6880494G55-O
to position the cursor to the left of the listing
<tab>
(see Figure 7-8).
<Return>
Command request accepted
Site Encoding Commands
in the
7-9
Advertisement
Table of Contents
