Table of Contents
Advertisement
Introduction
About this Manual
This manual describes the infrastructure command messages (ICMs) of the RF-Conductor!
controller used in the WMS-Data system. It is intended for network administrators and site
operators responsible for remotely downloading general purpose commands carried by the
SuperStream transport protocol to internal and external Network Interface Units (NIUs).
The organization of the manual follows the structure of the Infrastructure Commands sub-
menus of the WMS-Data Operator Console software (see Figure 1-1), and is divided in
sections, one for each main menu item:
•
Chapter 1, "Introduction", provides a description of the manual's purpose and contents.
Also included are the basic instructions on how to use the WMS-Data operator console
interface software.
•
Chapter 2, "Infrastructure Commands Overview", provides an overview of the
Infrastructure Commands Group menu.
•
Chapter 3, "Alignment Commands", describes adding and deleting a maintenance group,
changing alignment type, setting GPS offset and link path delay, and recalculating GPS.
•
Chapter 4, "SuperStream Commands", provides procedures for changing specific
parameters that uniquely identify each transmitter.
•
Chapter 5, "Diagnostic Commands", details the various diagnostic commands available
to the administrator: setting auxiliary outputs, resetting the dial modem, changing a
password, setting date and time, resetting NIU alarms, resetting a transmitter, setting bit
error rate (BER), setting Failsafe Timeout, and disabling paging.
•
Chapter 6, "Software Linkload Commands", provides procedures for downloading
software to the transmitters.
•
Chapter 7, "Site Encoding Commands", provides procedures for changing transmitter
color codes and channels, setting polarity for FLEX and POCSAG, and setting station ID
and mode.
•
Appendix A, "Configuring the Esprit 5055 Video Display Terminal" describes the
configuration of the Video Display Terminal (VDT) that is used as the RF-C!™ Controller
Operator Console.
1-2
RF-Conductor! Controller NIU Remote Configuration
6880494G55-O
May 1998
Advertisement
Table of Contents
