Table of Contents
Advertisement
This section provides additional programming bar codes to configure your reader by changing
the default settings. You must first enable your reader to read bar codes in order to use this
section. If you have not done this, go to Setup and follow the procedures described for your
handheld. Once the reader is set up, you can change the default parameters as needed for your
specific application.
PowerScan Configuration
Gryphon Configuration
PowerScan Configuration
Optional Settings
The following settings are optional. They are applicable only to PowerScan handhelds in
PreScan Multi Lane Mode. Use them to customize the settings for your PreScan system.
Reference the PreScan Integration Guide for planning considerations when determining the
optimal configuration settings for your setup.
•
•
•
•
•
•
•
•
•
MODE B option
Advanced Configuration Guide
starting on this page
starting on page 18
PowerScan Keypad Enable/Disable
Prompt Before Delete
on page 14
60-Minute Data Timeout on Inactivity
Beeper Control for Radio Response
Radio and Communication Timeouts (for Base)
"FIND ME" Function (Only for base models with button)
Next Session Prompt
on page 17
Clear Session Memory
on page 17
Clear Handheld Memory
on page 17
The Mode B option (=CT1 command) MUST be enabled according to the
RTS/CTS Hw handshake is enable (= CE1 command)
Handheld Configuration
on page 14
on page 15
on page 15
on page 16
on page 17
Chapter 3
13
Advertisement
Table of Contents
