Rapid Configuration; Step 1 - Connect The System; Ethernet Connections - Datalogic Matrix 120 Product Reference Manual

Step 1 - Connect the System

The paragraphs in this step show a typical hardware setup depending on the
Matrix 120 model and interface selection. Several other layouts are described in
Running H/F 1.

Ethernet Connections

To connect the system in an Ethernet point-to-point configuration, you need the
hardware indicated in
Host from the Matrix 120 on-board Ethernet interface by using a CAB-ETH-M0x
cable. There is no need to use a crossover adapter since Matrix 120 incorporates
an autocross function.
Matrix 120 power and I/O device connections take place through the CBX
connection box using the CAB-1011 accessory cable.
When One Shot or Phase Mode Operating mode is used, the reader is activated by
an External Trigger (photoelectric sensor) when the object enters its reading
zone.

Matrix 120
Product Reference Guide
Figure 1 -. In this layout the data is transmitted to the
CAB-ETH-M0x
CBX
CAB-1011


Figure 1 - Ethernet Point-to-Point Layout

Rapid Configuration

Host
Ethernet Interface

Main Serial Interface (RS232 or RS422 Full-Duplex

External Trigger (for One Shot or Phase Mode)

Chapter 1
1