D Transmitting An Individual Call - Icom IC-F5400DP Series Operating Manual

7
dPMR™ OPERATION
Transmitting a call

D Transmitting an Individual call

<Menu operation>
Portable: For the Ten-key and the Simple key types
Mobile: For the LCD types
(Menu > Signaling/Call > Call List Select)
1� Push [Menu] to display the Menu screen�
2� Push [Left] or [Right] to select "Signaling/Call,"
then push [OK]�
3� Push [Up] or [Down] to select "Call List Select,"
then push [OK]�
4� Push [Up] or [Down] to select an Individual station�
TIP: About the Direct Dial function
When you select "Direct Dial" at the end of the
list, you can directly enter an Individual ID using
[Up]/[Down] or Ten-key pad�
L Push [Left]/[Right] to move the cursor and push
[Back] to delete the entered ID�
L After entering, push [OK] to set the ID�
5� Push [PTT] to transmit the Individual call�
6� Hold down [PTT] and speak at your normal voice
level� Release [PTT] to receive�
7� After the communication is finished, push [Back]�
• The transceiver sends a Disconnect signal to
terminate the call�
L Either station can send a Disconnect signal�
TIP:
• You can transmit an Individual call through the
Call Menu� (Menu > Signaling/Call > Call menu)
• When an Individual ID is programmed in the
Memory CH, you can transmit the Individual call
by pushing [PTT] on the channel�
<Key operation>
Portable: For the Ten-key and the Simple key types
Mobile: For the LCD types
Using [Call List Select]:
1� Push [Call List Select] to display the "Call List
Select" screen�
2� Push [Up] or [Down] to select an Individual ID�
L See "TIP: About the Direct Dial function" in step 4
to the left�
3� Push [PTT] to transmit the Individual call�
4� Hold down [PTT] and speak at your normal voice
level� Release [PTT] to receive�
5� After the communication is finished, push [Back]�
• The transceiver sends a Disconnect signal to
terminate the call�
L Either station can send a Disconnect signal�
Using [Individual]:
1� Push [Individual] to display the "Individual Select"
screen�
2� Push [Up] or [Down] to select an Individual station�
L See "TIP: About the Direct Dial function" in step 4
to the left�
3� Push [PTT] to transmit the Individual call�
4� Hold down [PTT] and speak at your normal voice
level� Release [PTT] to receive�
5� After the communication is finished, push [Back]�
• The transceiver sends a Disconnect signal to
terminate the call�
L Either station can send a Disconnect signal�
TIP: You can display the "Individual Select" screen
through the Menu screen�
(Menu > Signaling/Call > Individual Select)
7-3