Table of Contents
Advertisement
5
SCAN OPERATION
Starting a Scan
A Scan checks for signals on each channel and stops
when a signal is received�
NOTE: Two or more channels must be preset to start
a Scan�
<Key operation>
Push [Scan Start/Stop] to start a Scan�
• "
" blinks� (Depending on the transceiver's version�)
When a signal is detected, the Scan pauses on the
channel until the signal disappears, and then the Scan
resumes�
<Menu operation>
Portable: For the Ten-key and the Simple key types
Mobile: For the LCD type
(Menu > Channel/Scan > Scan Start/Stop)
1� Push [Menu] to display the Menu screen�
2� Push [Left] or [Right] to select "Channel/Scan,"
then push [OK]�
3� Push [Up] or [Down] to select "Scan Start/Stop,"
then push [OK]�
4� Push [Up] or [Down] to select "ON," then push
[OK]�
• The Scan starts�
When a signal is detected, the Scan pauses on the
channel until the signal disappears, then the Scan
resumes�
5� Hold down [Back] for 1 second to return to the
standby screen�
• "
" blinks while scanning� (Depending on the
transceiver's version�)
5-2
Advertisement
Table of Contents
