Transmitting Dsc Calls; Transmitting An Individual Call - Icom iM323 Instruction Manual

Transmitting DSC calls

■
To ensure correct operation of the DSC function, make
sure you correctly set the CH70 SQL LEVEL. (p. 63)

Transmitting an individual call

D
The Individual call function allows you to transmit a DSC sig-
nal to only a specific station.
Enter "INDIVIDUAL CALL" in the DSC CALLS menu.
q
➪ DSC Calls
MENU
(Push [MENU]) (Rotate Dial, then push [ENT].)
Select the desired preprogrammed individual address, or
w
"Manual Input," using Dial or [Y]/[Z], then push Dial or
[ENT].
• The ID code for the Individual call can be set irst. (p. 19)
• When "Manual Input" is selected, set a desired 9 digit MMSI ID
code for the individual you wish to call.
•Push [EXIT] to return to the normal operating mode.
•Push [BACK] to return to the previous screen.
➪ Individual Call
About Manual Inputting:
Enter a desired individual ID in the following way:
• Select a desired number using Dial, or [Ω]/[≈].
• Push [ENT] or Dial to set it.
• To move the cursor, select either arrow, "←" or "→," then push
[ENT] or Dial.
• The irst digit is speciied as '0' for a Group ID. If a 9 digit Group ID
is entered, an error beep sounds when pushing [ENT] or dial.
• The irst two digits are '0' for any coast station ID.
NOTE: When a coast station is selected in this step, the
voice channel is automatically specified by the coast sta-
tion. Therefore, skip step e and go directly to step r.
Select a desired intership channel using Dial or [
e
[Z](CH), then push [ENT].
• Intership channels are already preset into the transceiver in the
recommended order.
7
DSC OPERATION
Y](CH)/
+ Continued on the next page.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
27