Turning On The Bluetooth ® Function; D For The Portable Non-Display Types And Mobile Segment Types - Icom IC-F5400DP Series Operating Manual

11
Bluetooth ® OPERATION
Turning ON the Bluetooth

D For the Portable Non-display types and Mobile Segment types

This section describes how to turn ON the Bluetooth
function and start pairing using the Portable Non-
display types or Mobile Segment types�
NOTE: For the Portable Ten-key and the Simple
key types and Mobile LCD types
• To turn ON the Bluetooth
• To pair with a headset:
• To pair with a data device:
Portable:
Step 1: Entering the Bluetooth
1� Turn OFF the transceiver�
2� Set [Selector] to any channel other than Channel
16�
3� While holding down [F1], turn ON the transceiver�
Continue holding down [F1] for about 3 seconds�
• 2 beeps sound�
• The transceiver enters the Bluetooth
Step 2: Entering the Pairing mode
L See the Bluetooth ® device's instruction manual for
details�
Step 3: Turning ON the Bluetooth
After the headset has entered the Pairing mode, push
[F2] to turn ON the Bluetooth
• The transceiver automatically enters the Pairing mode, and
begins searching for a Bluetooth
• While searching, the status indicator quickly blinks blue�
L If the status indicator does not blink after pushing [F2],
the transceiver has not entered the Bluetooth
In that case, do step 1 again�
Step 4: Pairing with a headset
When a headset is found, the transceiver pairs with it�
• After the transceiver and the headset pairing has
succeeded, the Status indicator slowly blinks blue 3 times�
In that case, the connection to the headset has also
succeeded�
L  T hetransceiversearchesforaheadsetfirst.After
searching for a headset, the transceiver will start
searching for a data device� To skip searching for a data
device, push [PTT] on the headset�
L If the Bluetooth ® connection fails, the Status indicator
slowly blinks red 3 times� To search for a headset again,
push [F3] to turn OFF the Bluetooth
[F2] to turn it ON again�
® function
® function: See page 11-3
See page 11-6
See page 11-9
® Set mode
(Transceiver)
® Set mode�
(Bluetooth ® device)
® function
(Transceiver)
® function�
® headset�
® Set mode�
(Transceiver)
® function, then push
®
Step 5: Pairing with a data device
1� When a data device is found, the transceiver pairs
with it�
• After the transceiver and the data device pairing has
succeeded, the Status indicator slowly blinks blue 3
times� In that case, connection to the data device has
also succeeded�
L If the Bluetooth
slowly blinks red 3 times� To search for a data device
again, push [F3] to turn OFF the Bluetooth
then push [F2] to turn it ON again� The transceiver
automatically tries to connect�
2� Turn OFF the transceiver, then turn it ON again to
exit the Bluetooth
[F1]
[F2]
[F3]
TIP: To turn OFF the Bluetooth
in the Bluetooth
11-4
® connection fails, the Status indicator
® Set mode�
[VOL]
® function, push [F3]
® Set mode�
(Transceiver)
® function,