Move 5000 Terminal Bluetooth Base - Ingenico Tetra PTS190 Operating Manual

SKYZER TECHNOLOGIES PAGE 15 OF 140

2.8 Move 5000 Terminal Bluetooth Base

Is used for charging the terminal battery and has ports to allow terminals to
communicate with hosts over Ethernet and Dial up.
You should set up your base unit in a convenient location close to a power
source and network point.
To open the base unit cover, located on the bottom of the base unit, you must
unclip an access clip and lift the cover from the base unit. To replace the
cover reverse these instructions being sure to engage all the retaining pins
before the access clips.
COM0 (Serial/RS232) Port
Figure 3 – Feature of Move 5000 Base
INGENICO Tetra PTS190 Paymark Operating GuideVersion 1.02