Multi-Merchant Configuration - Ingenico Tetra PTS190 Operating Manual

SKYZER TECHNOLOGIES

6.6 Multi-Merchant Configuration

This function is used to configure the terminal for Multi-merchant operation. The
terminal can support up to 8 Merchants.
NOTE: After activating the Multi-Merchant configuration, please return to
EFTPOS configuration for Multi-Merchant Function 3824 to enter the Terminal
and Merchant ID's for the active merchants.
Step Terminal Display Description
1.0
2.0
FUNCTION?
3.0
MULTI MERCHANT
SETUP
4.0
ACTIVE MERCHANTS
12345678
5.0
MULTI MERCHANT
SETUP
6.0
MERCHANT 1 NAME
MERCHANT 1
7.0
MULTI MERCHANT
SETUP
INGENICO Tetra PTS190 Paymark Operating GuideVersion 1.02
Press FUNC
Enter 7418, press ENTER
Terminal is now in configuration mode. Go to following steps to proceed or press
CANCEL to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
Press 3 to Set Active Merchants
Enter the number (from 1 – 8) for each individual merchant you wish to activate
and press ENTER
Example: To activate merchants 1 to 5, enter 12345
Terminal is now in configuration mode. Go to following steps to proceed or press
CANCEL to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
Press 4 to Manually Set Merchant Name
To change the merchant name, use the numeric keypad then the FUNC key to
access the alpha characters. Press ENTER to advance to the next merchant name
NOTE: If the merchant name is not set, then terminal will automatically
use the names that are on the Paymark receipt header
Terminal is now in configuration mode. Go to following steps to proceed or press
CANCEL to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
PAGE 48 OF 140