Ingenico Tetra PTS190 Operating Manual page 35

SKYZER TECHNOLOGIES
7.0
PABX?
1A
or
1W
8.0
HOST PHONE NO?
08797
9.0
USE DNS Y/N
1-YES 2-NO
10.0
GPRS Primary
HOST DNS
gprs.paymark.co.nz
11.0
GPRS Secondary
Host DNS
gprs2.paymark.co.nz
12.0
USE DNS Y/N
2-NO
13.0
GPRS Primary
HOST IP ADDRESS
117.120.35.3
14.0
GPRS Secondary
HOST IP ADDRESS
117.120.33.3
15.0
SAVE CONFIG Y/N
16.0
START GPRS Y/N
INGENICO Tetra PTS190 Paymark Operating GuideVersion 1.02
Press ENTER to bypass if no PABX prefix is required.
This parameter specifies the PABX numbers that the terminal dials to access an
outside line.
Note: The terminal pauses for 1 second after dialling if a control character 'A' is
inserted or to pauses for couple of seconds after dialling if a control character 'W' is
inserted after the PABX number. To insert a control character 'A' or 'W', press the
corresponding number key and then the FUNC key.
To remove a PABX number from the PABX field, press 1 and then press FUNC key
until space is displayed followed by ENTER.
This parameter specifies the phone number of Paymark network to dial to. By
default, the host phone number is set as 08797. Press ENTER.
NOTE: If the merchant has the Toll Bar on the site, then key in this phone
number 1797 to obtain connectivity to Paymark network.
Press the corresponding number key and press ENTER to set for DNS or IP
Option 1 – to allow the terminal to use Paymark DNS address. Option 1 is
selected by default.
This parameter specifies the Paymark Primary DNS address. By default, it is set to
grps.paymark.co.nz. Press ENTER
This parameter specifies the Paymark Secondary DNS address. By default, it is set
to gprs2.paymark.co.nz. Press ENTER
Option 2 – to allow the terminal to use Paymark IP address.
This parameter specifies the GPRS Primary IP address. By default, it is set to
117.120.35.3. Press ENTER.
This parameter specifies the GPRS Secondary IP Address. By default, it is set to
117.120.33.3. Press ENTER.
Terminal prompts to save configuration. Press ENTER to save configuration on the
terminal or CLEAR to exit and return to idle screen.
Terminal prompts to start GPRS link. Press ENTER to start GPRS or CLEAR to exit
without starting GPRS link to Paymark.
PAGE 35 OF 140