Ingenico Tetra PTS190 Operating Manual page 29

SKYZER TECHNOLOGIES
9.0
PABX?
1A
or
1W
10.0
HOST PHONE NO?
08797
11.0
USE DNS Y/N
1-YES 2-NO
12.0
IP Primary
HOST DNS
direct.paymark.co.nz
13.0
IP Secondary
Host DNS
direct2.paymark.co.n
14.0
USE DNS Y/N
2-NO
15.0
IP Primary
HOST IP ADDRESS
117.120.34.110
16.0
IP Secondary
HOST IP ADDRESS
117.120.32.110
17.0
SAVE CONFIG Y/N
18.0
START TCP-IP Y/N
INGENICO Tetra PTS190 Paymark Operating GuideVersion 1.02
Press ENTER to bypass if no PABX prefix is required.
This parameter specifies the PABX numbers that the terminal dials to access an
outside line.
Note: The terminal pauses for 1 second after dialling if a control character 'A' is
inserted or to pauses for couple of seconds after dialling if a control character 'W' is
inserted after the PABX number. To insert a control character 'A' or 'W', press the
corresponding number key and then the FUNC key.
To remove a PABX number from the PABX field, press 1 and then press FUNC key
until space is displayed followed by ENTER.
This parameter specifies the phone number of Paymark network to dial to. By
default, the host phone number is set as 08797. Press ENTER.
NOTE: If the merchant has the Toll Bar on the site, then key in this phone
number 1797 to obtain connectivity to Paymark network.
Press the corresponding number key and press ENTER to set for DNS or IP
Option 1 – to allow the terminal to use Paymark DNS address. Option 1 is
selected by default.
This parameter specifies the Paymark Primary DNS address. By default, it is set to
direct.paymark.co.nz. Press ENTER
This parameter specifies the Paymark Secondary DNS address. By default, it is set to
direct2.paymark.co.nz. Press ENTER
Option 2 – to allow the terminal to use Paymark IP address.
This parameter specifies the Primary Host IP Address. By default, it is set to
117.120.34.110. Press ENTER.
This parameter specifies the Secondary Host IP Address. By default, it is set to
117.120.32.110. Press ENTER.
Terminal prompts to save configuration. Press ENTER to save configuration on the
terminal or CLEAR to exit and return to idle screen.
Terminal prompts to start TCP-IP link. Press ENTER to start the link or CLEAR to
exit without starting.
PAGE 29 OF 140