Installing The Terminal On The Base; Installation; Recommendations; Terminal Connections - Ingenico IWL2 series User Manual

Contactless (optional)
•
Bring the card firmly up to the active zone. Keep the
card close to the reader during the transaction
•
The 4 LEDs indicate transaction processing (as shown
on the pictu re) . On color screen terminal virtual LEDs
are displayed.
The terminal behavior for the cardholder may depend on:
•
The terminal environment
•
Local usag e (language...)
3.4.

Installing the terminal on the base

Connecting the terminal on the base
Place the iWL2XX between the flanges on its base so that the contacts of the iWL2XX
engag e on the contacts provided on the base (see picture below).
Using the modem base (if modem fitted on your base)
Once installed, the base modem is designed to always be plugged into the mains network
and be connected to a telephone line. The telephone line should not be shared.
The portable may be placed back on its base after each transaction. It must be placed on its
modem base when telephone network is used for : au thorization request, remote
collection, downloading.
•
iWL2xx Wireless Series 9/32
900003061 R11 000 05/1122
4 leds
(B&W display only)
Active
zone
Copyright © 2011 Ingenico
All rights reserved
4.

Installation

4.1.

Recommendations

Location of the iWL2xx
Place the base on flat surface near an electric socket and, if modem option, a telephone
socket. The terminal should be placed far from any very hot zones, protected from
vibrations, dust, damp and electromagnetic radiation (computer screen, anti-theft barrier
etc.).
The terminal must not be fixed to a counter in such a way that a user cannot pick up the
terminal and use his/her body to conceal the PIN when it is requested.
Operating conditions
Ambiant temperature from -10°C to +40°C
Max relative humidity 85% at +40°C
Charg ing conditions
Ambiant temperature from 0°C to +40°C
Storage conditions
Ambiant temperature from -20°C to +55°C
Max relative humidity 85% at +55°C
4.2.

Terminal connections

•
There is an USB connector (microAB) on the left side of the iWL2XX Wireless
terminal (see below picture). This connector manag es Host or Slave connexions.
USB (microAB)
Connector us ed f or PC, travel
charger adapter, USB Key, etc ...)
CAU TION :
Do not turn USB protection sh ell down side. Turn shell in clockwise direction to uncap
connector. And reverse to cap back
*MicroAB connector durability : up to 10000 mating cycles
•
The terminal supports USB Keys with FAT16 or FAT32
•
The USB Key has to be used with an USB adapter (refers to accessories section)
•
iWL2xx Wireless Series 10/32
900003061 R11 000 05/1122
Copyright © 2011 Ingenico
All rights reserved