Ingenico Tetra PTS190 Operating Manual page 21

SKYZER TECHNOLOGIES
6.0
General settings
Human interface
ECO mode
Communication
means
7.0
Bluetooth
Wifi
Mobile Networks
Ethernet
Modem PABX
Modem settings
8.0
Switch on
9.0
Switch off
Phone paring
Add peripherals
Paired devices
Advance options
Base
10.0
Association
Advanced
Base State
Upgrade Base
11.0
New base
Select base
Remove base
Print base
12.0
Association
Successful
13.0
INGENICO Tetra PTS190 Paymark Operating GuideVersion 1.02
Select COMMUNICATION MEANS on the terminal screen
NOTE: DO NOT SELECT ANY OTHER FUNCTIONS
Select Bluetooth on the terminal screen.
Select SWITCH ON on the terminal screen. Terminal will then display Setting
Bluetooth power on terminal screen
NOTE: DO NOT SELECT ANY OTHER FUNCTIONS
Select BASE on the terminal screen.
NOTE: DO NOT SELECT ANY OTHER FUNCTIONS
Select ASSOCIATION on the terminal screen.
NOTE: DO NOT SELECT ANY OTHER FUNCTIONS
Select NEW BASE on the terminal screen. Terminal will immediately perform
association with that base. The terminal will display the outcome of the association
attempt.
Terminal will display ASSOCIATION SUCCESSFUL on the screen. Press ENTER
or after few seconds later terminal will return to previous screen step 11.0.
Press the CANCEL key unless and until you exit out from the menu and return to
idle screen.
PAGE 21 OF 140