Installing A Paper Roll - Ingenico Tetra PTS190 Operating Manual

SKYZER TECHNOLOGIES
NOTE: For best performance use only heat sensitised paper roll approved by
Ingenico. The use of non-approved paper is likely to damage the terminals
printer

10.8 Installing a Paper Roll

• Open the paper compartment by lifting the catch located at the rear of
the terminal and pull the cover to the rear of the terminal.
• Insert the paper roll in the compartment following the directions shown in
the picture
• Pull the paper up to the top of the terminal • Hold the paper and close
the lid
• Press simultaneously on both upper corners of the paper flap, as shown
by arrows on picture, until it clips into position
NOTE: When a new paper roll is inserted, tear off the first length (one complete
turn) to avoid printing on the residue of the adhesive tape.
INGENICO Tetra PTS190 Paymark Operating GuideVersion 1.02
PAGE 137 OF 140