To Deactivate Multi-Merchant Configuration - Ingenico Tetra PTS190 Operating Manual

SKYZER TECHNOLOGIES

6.8.2 To Deactivate Multi-Merchant Configuration

This function allows the merchant to deactivate multi-merchants on the
terminal if not required.
Step Terminal Display Description
1.0
2.0
FUNCTION?
3.0
MULTI MERCHANT
SETUP
4.0
ACTIVE MERCHANTS
1
5.0
MULTI MERCHANT
SETUP
INGENICO Tetra PTS190 Paymark Operating GuideVersion 1.02
Press FUNC
Enter 7418, press ENTER
Terminal is now in configuration mode. Go to following steps to proceed or press
CANCEL to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
Press 3 to Deactivate Active Merchants
Terminal will display with all active merchants that was previous configured. To
deactivate multi-merchant from the terminal, key in the active merchant number
that the merchant desire to have active followed by the ENTER. This will result in
deactivating the other active merchants on the terminal.
Example: To deactivate merchants 2 to 5, enter the merchant number 1 to have
active and other active merchants will be deactivated.
Terminal is now in configuration mode. Press CANCEL to exit, otherwise the
terminal will automatically exit after 30 seconds of inactivity
PAGE 53 OF 140