Remote Key Injection (Pkms); Remote Key Injection (Pkms) Configuration; Dial-Up Rki Configuration - Ingenico Tetra PTS190 Operating Manual

SKYZER TECHNOLOGIES

6.11 Remote Key Injection (PKMS)

The Ingenico Move 5000 terminal supports Remote Key Injection technology to
enable automated injection of security keys from Paymark.

6.11.1 Remote Key Injection (PKMS) Configuration

This function is used to configure the Remote Key Injection operation and can
be performed through Dial-up, TCP-IP (Broadband) and GPRS mode.
6.11.2

Dial-up RKI Configuration

Step Terminal Display Description
1.0
2.0
FUNCTION?
3.0
MULTI MERCHANT
SETUP
4.0
MULTI MERCHANT
SETUP
5.0
RKI CONFIG?
ENTER OR CLEAR
6.0
NII?
018
7.0
RKI PHONE NO?
08797
8.0
MULTI MERCHANT
SETUP
INGENICO Tetra PTS190 Paymark Operating GuideVersion 1.02
Press FUNC
Enter 7418, press ENTER
Terminal is now in configuration mode. Go to following Steps to proceed or Press
CANCEL to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
Select option 5 for RKI configuration by pressing the corresponding number key.
Press ENTER to proceed with the RKI configuration or CLEAR to cancel and exit to
idle screen
This parameter specifies the Network International Identifier that the terminal uses
to route messages to Paymark.
Press ENTER.
This parameter specifies the Phone number of the Paymark Host, where it will be
connecting to download the keys. By default, the RKI phone number is set as
08797.
NOTE: If the merchant has the Toll Bar on the site, then key in this phone
number 1797 to obtain connectivity to Paymark network.
Terminal is now in configuration mode. Press CANCEL to exit, otherwise the
terminal will automatically exit after 30 seconds of inactivity
PAGE 58 OF 140