Paper Roll; Charging The Battery Using The Terminal Power Supply - Ingenico Tetra PTS190 Operating Manual

SKYZER TECHNOLOGIES
10.6.4

Charging the Battery Using the Terminal Power Supply

• Connect the terminal power supply unit to the terminal charging port on
the left of the terminal.
• The battery symbols are:
Battery charge greater than 80%
Battery charge greater than 60% and less than 80%
Battery charge greater than 40% and less than 60%
Battery charge greater than 20% and less than 40%
Battery charge less than 20%
Terminal powered by external power supply, battery full charge
• The environment in which the charge takes place influences battery
lifetime and autonomy (number of transactions)
• The optimal conditions are as follows:
- Charge away from any external heat source (radiator, sun, enclosed
area etc.)
- The optimal temperature is between +15°C and +25°C

10.7 Paper Roll

Main characteristics of Ingenico paper roll:
• Colour White
• Width 58 mm
• Diameter 40 mm
• Length Approximately 18 meters
The quality of the thermal paper can be deteriorated by poor storage
conditions; it is therefore recommended that the following are avoided:
• Storage in hot wet places (near air-conditioners, humidity above 85%)
• Exposure to sunlight or ultraviolet for long periods
• Contact with organic solvents (solvent type adhesives)
• Direct contact with materials containing plasticizers (PVC transparent
folders or envelopes)
• Direct contact with "diazo" papers
• Direct contact with water
• Rubbing or pressing the paper too strongly
INGENICO Tetra PTS190 Paymark Operating GuideVersion 1.02
PAGE 136 OF 140