How To Change A Paper Roll; Insuring Your Terminal; Security Warning Notice - Ingenico iCT200 Series User Manual

38. How to Change a Paper Roll

1. Hold the terminal securely in one hand. With the other hand, and by using two fingers, lift the
printer cover release as shown. Fully open the printer cover and remove the old roll of paper.
1
3
2. Unstick the end of the new roll. Leaving the end free, hold the paper roll and carefully place into
the printer compartment.
3. Holding the free end of the paper and your terminal, close the printer cover carefully and push
firmly until it locks.
4. While your terminal is displaying the idle screen, press and hold the YELLOW button to ensure
that the paper feeds correctly. Only paper rolls that are 57mm wide and 40mm in diameter can be
used in your terminal. Attempting to fit rolls of a different size may damage your terminal.

39. Insuring your terminal

Although you rent your terminal for a monthly charge it is strongly recommended that you insure
the terminal against loss or damage to a value as recommended by your acquirer.

40. Security Warning Notice

This terminal is used for the secure transfer of funds using credit and debit cards. As such it is
designed as a high security device. Should you suspect that the terminal might have been
removed, stolen or apparently modified or replaced then you should advise your Bank
immediately and stop using the terminal until advised by the Bank accordingly. This is to protect
both your business and also the persons who have or will continue to use your terminal.
Please be vigilant at all times and check your terminal regularly.
Page 34
2
4