Table of Contents
Advertisement
SKYZER TECHNOLOGIES
13.9 REPLACING PAPER ROLL
o Insert the paper roll in the compartment following the directions shown
on the figure below.
o Pull the paper up to the top of the terminal and hold it in this position.
o Maintain the paper and close the lid.
o Press the top of the lid in the centre as shown by arrow, until it clips into
position.
ADVISE: If you are inserting a new roll, tear off the first length (one complete
turn).
13.10 PAPER SIZE
The paper roll size is 58mm width and 40mm diameter max.
13.11 OPENING SIM CARD COMPARTMENT COVER
In order to access the GPRS SIM card slot, you must first remove the SIM card
compartment cover located at the back of your terminal.
o Press down firmly on the middle of the back cover and slide it as
indicated by the arrow as shown on the figure.
INGENICO ICT2XX 2017 PAYMARK SOFTWARE OPERATING GUIDE
PAGE 143 OF 146
VERSION 1.0
Advertisement
Table of Contents
