Two-Speed Timer Setup; Figure 5-12 Two-Speed Timer Setup - Emerson Bettis TEC2 Installation And Operation Manual

Section 5: Customizing Actuator Settings
February 2018
5.5.7

Two-Speed Timer Setup

The two-speed timers can be configured for the actuator to be controlled with
different opening and closing times. All configured timers are active in the LOCAL
and REMOTE modes.
NOTE:
All three timers, close, open, and anti-water hammer, can operate at the same time.
If two timer ranges overlap, the anti-water hammer timer overrides all timers.
1.
2.
3.
4.
Figure 5-12 Two-Speed Timer Setup
Go to
Figure 5-4
NO
TWO-SPEED CLOSE
TIMER SETUP? TIMER SETUP?
YES
NO
OPEN
TIMER SETUP?
NO
ANTI-WATER
HAMMER SETUP?
NO
58
All manuals and user guides at all-guides.com
At the "TWO-SPEED TIMER SETUP?" prompt answer "YES."
Use the selector knob (NEXT/BACK) to review the settings for each timer.
Use the control knob (NO) to select either ON or OFF, increment the
position percentage, and pulse time.
Answer "YES" after each selection. See Figure 5-12.
Figure 5-12 Two-Spead Timer Setup
Close Timer Timer Start
<On / O > Position:
YES YES
<xx>%
NO
Increment Position
1-99% in Steps of 1%
Open Timer Timer Start
<On / O > Position:
YES
YES
<xx>%
NO
Increment Position
1-99% in Steps of 1%
Anti-Water
Timer Start
Hammer Position:
YES
YES
<On / O > <xx>%
YES
Increment Position
1-30% in Steps of 1%
Installation and Operation Manual
Timer Stop Pulse On Time:
Position: <xx.x> Sec
YES YES
<xx>%
NO NO
1-10 sec in
Increment Position
1-99% in Steps of 1% 0.5 sec Increments
Timer Stop Pulse On Time:
Position: <xx.x> Sec
YES YES
<xx>%
NO NO
1-10 sec in
Increment Position
1-99% in Steps of 1% 0.5 sec Increments
Pulse On Time:
<xx.x> Sec
YES YES
NO
1-10 sec in
0.5 sec Increments
Customizing Actuator Settings
E2K-405-0218 Rev. 2
Pulse Off Time:
<xx.x> Sec
YES YES
NO
1-100 sec in
1 sec Increments
Pulse Off Time:
<xx.x> Sec
YES YES
NO
1-100 sec in
1 sec Increments
Pulse Off Time:
<xx.x> Sec
YES
NO
1-100 sec in
1 sec Increments