Figure 4-4 Display Settings - Emerson Bettis TEC2 Installation And Operation Manual

Section 4: Operation
February 2018
Figure 4-4 Display Settings
Go to
Figure 5-1
BACK
VALVE CONTROL
Control Mode
SETUP?
YES
<control mode>
Two-wire; Three-wire; Four-wire
IrDA port; Three-wire Analog
Analog - ignored if ACM not installed
Network - ignored if ACM not installed
Open Torque Local Control
YES
<xx>% <LocalCtrlSetting>
Remote Display 2 Close LED<color>
YES
<on/o > Open LED<color>
36
All manuals and user guides at all-guides.com
Figure 4-5 Display Settings
Drive Sleeve
YES YES
Close: <cw or ccw>
Remote Control
YES YES
<RemoteCtrlSetting>
Low Battery
YES YES
Alarm<on/o >
OR
NEXT
Installation and Operation Manual
BACK NEXT
<pos or trq> Torque
YES
Position Seat Backseat <on/o >
Torque Retry Remote Display 1
YES
<on/o > <on/o >
Go to
Figure 5-9
E2K-405-0218 Rev. 2
Close Torque
YES
<xx>%
YES
YES
Operation