Installation and Operation Manual
E2K-405-0218 Rev. 2
5.5.1
Passcode Entry
The actuator is shipped with "000" as a passcode. To change the passcode see
Section 5.5.11, Passcode Setup.
To enter the passcode:
1.
2.
3.
Customizing Actuator Settings
All manuals and user guides at all-guides.com
At the "CHANGE SETTINGS?" prompt answer "YES." "ACCEPT PASSCODE
CHARACTER 1? X" will appear. "X" will be flashing. "X" is the first "left
most" character in the passcode.
If this character is correct, select YES. If not select NO. Use NO to
increment from 0-9 and then A-Z until the correct character is displayed.
Select YES. The second character will flash.
NOTE:
When "Z" is displayed the data will rollover to "0" and
continue incrementing.
Repeat Step No. 2 for the second and third characters.
NOTE:
If the passcode is not the correct passcode, the display will return to
"CHANGE SETTINGS?" display. See Figure 5-5.
Section 5: Customizing Actuator Settings
February 2018
47