Table of Contents
Advertisement
Display Close
Torque
Archive?
Installation and Operation Manual
NO
E2K-405-0218 Rev. 2
6.2.5
Display Operation Archive
Operation archive displays operation data from the initial commissioning.
DISPLAY OPERATION LOG
See Figure 6-5. The operation archive cannot be reset in the "CHANGE SETTINGS"
mode. The operation archive can be reset in the "FACTORY SETUP" mode;
however the actuator must be decommissioned and travel limits must be reset
before operating as detailed in Section 4.3.1, Setting Position Limits.
DISPLAY
OPERATE LOG?
1.
YES
NO
2.
OR
NEXT
Figure 6-5
Display Operation Archive
DISPLAY OPERATION ARCHIVE
DISPLAY
OPERATE ARCHIVE?
YES
NO
OR
NEXT
6.2.6
Display Hardware
This display reports the status of the modules and can identify which module is at
DISPLAY
fault if a problem exists with the actuator. Typical status report can include:
HARDWARE?
YES
NO
•
OR
NEXT
•
NO
•
•
1.
2.
See Figure 6-6.
Troubleshooting
EXIT?
@10 Torque =
<xx>%
YES
YES
All manuals and user guides at all-guides.com
@20 Torque =
<xx>%
Figure 6-4
Motor
Strokes
Starts
<xxx,xxx,xxx>
At the "DISPLAY OPERATE ARCHIVE" prompt, answer "YES."
YES
<xxx,xxx,xxx>
Use the control knob (YES) to review the operation archive.
NO
NO
Figure 6-5
Motor
Strokes
Starts
<xxx,xxx,xxx>
YES
<xxx,xxx,xxx>
NO
NO
DISPLAY HARDWARE
Figure 6-6
APD Module
Inside
<apd_state>
Temperature=
YES
<state: NORMAL/
<xx>C
FAILED>
Normal
NO
Not Configured
NO
Lost Link
Refresh every
30 seconds
Failed
At the "DISPLAY HARDWARE?" prompt, answer "YES."
Use the control knob (YES) to review the hardware status.
REMOTE
DISPLAY#2
<rem_disp#2_state>
<state: NORMAL/
YES
NOT CONFIGURED/
LOST LINK/FAILED>
@30 Torque =
@50 Torque =
<xx>%
YES
@40 Torque =
@60 Torque =
<xx>%
Section 6: Troubleshooting
NO
NO
BACK
Motor
Run Time
YES
<hr:min:sec>
NO
BACK
Motor
Run Time
YES
<hours>
NO
Central Control
<cen_ctrl_state>
YES
<state: NORMAL/
LOST LINK /FAILED>
NO
Analog
Network
<analog_state>
<network_state>
<state: NORMAL/
<state: NORMAL/
NOT CONFIGURED/
NOT CONFIGURED/
YES
UNDER RANGE/
SPI LINK LOST/ACM
OVER RANGE>
FAILED/HOST LOST
NO
NO
BACK
NEXT
@70 Torque =
<xx>%
<xx>%
YES
@80 Torque =
<xx>%
<xx>%
February 2018
NO
NEXT
YES
NEXT
YES
Local Display
<lcl_disp_state>
YES
YES
<state: NORMAL/
LOST LINK /FAILED>
NO
EFM
<efm_state>
<state: NORMAL/
SHUTDOWN/
YES
FAILED>
77
@90 Torqu
YES
<xx>%
NO
REMOTE
DISPLAY#1
<rem_disp#1_state>
YES
<state: NORMAL/
NOT CONFIGURED/
LOST LINK / FAILED>
NO
NO
YES
NO
Advertisement
Table of Contents
