Table of Contents
Advertisement
Installation and Operation Manual
E2K-405-0218 Rev. 2
The position limits are now set. The actuator will operate in the normal LOCAL and
REMOTE modes.
NOTE:
The user is not required to exit setup after setting limits for the first time. At the completion
of setting the limits, the actuator should be in the "STOP" mode and the valve should be at
its open limit. The LDM should display "100%," and the red LED should be ON. The graphics
display of the valve should represent full open.
Figure 2-1
Declutch Lever
Hand Crank
Handwheel
Quick Start
All manuals and user guides at all-guides.com
Declutch Lever and Handwheel
TEC2000/TEC2 Enclosure
TEC2000/TEC2 Enclosure
Model 500 Enclosure
Section 2: Quick Start
February 2018
Declutch Lever
Declutch Lever
5
Advertisement
Table of Contents
