Auxiliary Relay Module (Arm) Wiring; Figure 3-18 Arm Wiring Diagram; Table 3-2 Arm Wiring Connections - Emerson Bettis TEC2 Installation And Operation Manual

Installation and Operation Manual
E2K-405-0218 Rev. 2
3.7

Auxiliary Relay Module (ARM) Wiring

The ARM can be used with the Futronic ACM or standalone. Only factory-trained
technicians may install the ARM.
Connect the ARM within the controller in accordance with Table 3-2. See Section 3.3,
Electrical Connections for general electrical connection requirements.
Table 3-2.
Terminal Block
39
40
41
42
43
44
Figure 3-18
Alternate Default
Function Function
Open
Close
Stop
Common (0V) for Control Inputs (1-3)
Open Inhibit
Close Inhibit
ESD
Common (0V) for Inhibit/ESD Inputs (4-6)
User Power Supply 24VDC Power Supply
Relay Output #1 Limit Switch Open (LSO)
Relay Output #2 Limit Switch Close (LSC)
Relay Output #3 Intermediate Limit A (LSA)
Relay Output #4 Intermediate Limit B (LSB)
Relay Output #5 Monitor Relay N.O.
Emergency Stop (N.C.)
Remote Display Model Communication Port (+)
Emergency Stop (N.C.)
Remote Display Model Communication Port (-)
Installation
All manuals and user guides at all-guides.com
ARM Wiring Connections
Function
Relay Output #9
Common
Relay Output #10
Relay Output #11
Common
Relay Output #12
ARM Wiring Diagram
Signal
Digital Input #1
Digital Input #2
Digital Input #3
Digital Input #4
Digital Input #5
Digital Input #6
}
(+)
(-)
}
}
}
}
}
}
Monitor Relay N.C.
Earth Ground
Section 3: Installation
February 2018
Relay Type
Latching NO or NC
Latching NO or NC
Latching NO or NC
Latching NO or NC
AIN1+
AIN1-
AIN2+
ACM Option
AIN2-
Shield
All Analog I/O are Isolated,
Shield
Loop Powered
AO1+
with Channel to Channel Isolation
AO1-
AO2+
AO2-
Spare (n/c)
DCMlink (+)
Spare (n/c)
DCMlink (-)
Relay Output #9
Common Relays 9 & 10
Relay Output #10
ARM Option
Relay Output #11
Common Relays 11 & 12
Relay Output #12
ACM_ARM Option
23