Two-Speed Timer Setup; Figure 5-12 Two-Speed Timer Setup - Emerson Bettis 500 Installation And Operation Manual

Section 5: Customizing Actuator Settings
February 2018
5.5.7
Figure 5-12

Two-Speed Timer Setup

Go to
Figure 5-4
NO
TWO-SPEED CLOSE
TIMER SETUP? TIMER SETUP?
YES
NO
OPEN
TIMER SETUP?
NO
ANTI-WATER
HAMMER SETUP?
NO
58
Two-Speed Timer Setup
The two-speed timers can be configured for the actuator to be controlled with
different opening and closing times. All configured timers are active in the LOCAL
and REMOTE modes.
NOTE:
All three timers, close, open, and anti-water hammer, can operate at the same time.
If two timer ranges overlap, the anti-water hammer timer overrides all timers.
1. At the "TWO-SPEED TIMER SETUP?" prompt answer "YES."
2. Use the selector knob (NEXT/BACK) to review the settings for each timer.
3. Use the control knob (NO) to select either ON or OFF, increment the
position percentage, and pulse time.
4. Answer "YES" after each selection. See Figure 5-12.
Figure 5-12 Two-Spead Timer Setup
Close Timer
<On / O >
YES YES
Increment Position
1-99% in Steps of 1%
Open Timer
<On / O >
YES
YES
Increment Position
1-99% in Steps of 1%
Anti-Water
Hammer
YES YES
<On / O >
Increment Position
1-30% in Steps of 1%
Installation and Operation Manual
Timer Start Timer Stop
Position: Position:
YES
<xx>% <xx>%
NO NO
Increment Position
1-99% in Steps of 1%
Timer Start Timer Stop
Position: Position:
YES
<xx>% <xx>%
NO NO
Increment Position
1-99% in Steps of 1%
Timer Start Pulse On Time:
Position: <xx.x> Sec
YES
<xx>%
YES
NO
1-10 sec in
0.5 sec Increments
E2K-405-0218 Rev. 2
Pulse On Time: Pulse Off Time:
<xx.x> Sec <xx.x> Sec
YES YES
NO NO
1-10 sec in 1-100 sec in
0.5 sec Increments 1 sec Increments
Pulse On Time: Pulse Off Time:
<xx.x> Sec <xx.x> Sec
YES YES
NO NO
1-10 sec in 1-100 sec in
0.5 sec Increments 1 sec Increments
Pulse Off Time:
<xx.x> Sec
YES
NO
1-100 sec in
1 sec Increments
Customizing Actuator Settings
YES
YES
YES