Discrete Output Setup; Table 5-1 Relay Outputs #1 Through #5 Configuration - Emerson Bettis TEC2 Installation And Operation Manual

Installation and Operation Manual
E2K-405-0218 Rev. 2
5.5.5

Discrete Output Setup

Relay outputs are used primarily for hard wired status feedback. Each relay
may be configured (assigned) to various status, alarm, or control functions.
Relay outputs can be configured to be active on the listed alarms/conditions.
Relay outputs #1 through #5 are standard and may be configured as shown in
Table 5-1. Configurable functions are listed in Table 5-2.
To configure the relays:
1.
2.
3.
See Figure 5-10.
Table 5-1.
Customizing Actuator Settings
All manuals and user guides at all-guides.com
At the "DISCRETE OUTPUT SETUP?" prompt answer "YES."
Use the selector knob (NEXT/BACK) to review the settings for Discrete
Outputs.
Use the control knob (NO) to select desired configuration for each relay.
Relay Outputs #1 through #5 Configuration
Default
Relay
Function
LSO See Table 5-2
RO#1 Valve full Relay Output
OPEN Function List
LSC See Table 5-2
RO#2 Valve full Relay Output
CLOSE Function List
LSO See Table 5-2
RO#3 Valve Full Relay Output
Open Function List
LSC See Table 5-2
RO#4 Valve Full Relay Output
Close Function List
Monitor
Host Control –
RO#5 Valve not
see NOTE
available
Section 5: Customizing Actuator Settings
Configu-
Configure
rable
N.O./N.C.
Function
Yes N.O.
Yes N.O.
Yes N.O.
Yes N.O.
1 N.O. and
No
1 N.C.
February 2018
Default Configure
Setting Flashing
Yes
Yes
Yes
Yes
Yes
53