Dürkopp Adler 878-M PREMIUM Operating Instructions Manual page 95

Icon Parameter
Point position
The distance of the needle from the mate-
rial can be adjusted to allow precise
positioning of the sewing material when
starting sewing. The value entered here
corresponds to the degree number on the
handwheel.
Flat Sew
Transport correction at zero difference for
Flat Sew.
Gap
Value for the gap between the motor-driven
edge guide and the needle (factoring in the
defined safety distance to the sewing feet).
Correction speed effect
Correction speed effect
Stitch length
Needle thread tension
Sewing foot pressure
Material thickness detection
Material thickness detection
Stitch length
Operating Instructions 878-M PREMIUM - 06.0 - 11/2021
Settings
Value range
000–359 [°]
Value range
-20 to 20
Value range
8.0 to 45.0 [mm]
Value range
On/Off
(see  p. 97)
The stitch length changes slightly
depending on the speed.
For this reason, the stitch length
can be adjusted at different
speeds by the software.
Depending on the speed, the nee-
dle thread tension can be adjusted
at different speeds by the software.
Depending on the speed, the sew-
ing foot pressure can be adjusted
at different speeds by the software.
Value range
On/Off
(see  p. 100)
The stitch length changes slightly
depending on the material
thickness.
For this reason, the stitch length
can be adjusted to different mate-
rial thicknesses by the software.
93