Dürkopp Adler 878-M PREMIUM Operating Instructions Manual page 123

Icon Parameter
Counter Mode
Daily piece counter, can be set to count
either up or down.
Point position
The distance of the needle from the
material can be adjusted to allow
precise positioning of the sewing
material when starting sewing.
The value entered corresponds to the
degree number on the handwheel.
Flat Sew
Transport correction at zero difference
for Flat Sew.
Correction speed effect
Correction speed effect
Stitch length
Needle thread tension
Sewing foot pressure
Material thickness detection
Material thickness detection Value range
Operating Instructions 878-M PREMIUM - 06.0 - 11/2021
Settings
Off/Up/Down
Reset
When the daily piece counter is
activated, it must be reset once after
entering a value to ensure it counts
correctly.
000–359 [°]
Value range
-20 to 20
Value range
On/Off
(see  p. 125)
The stitch length changes slightly
depending on the speed. For this
reason, the stitch length can be
adjusted at different speeds by the
software.
Depending on the speed, the needle
thread tension can be adjusted at
different speeds by the software.
Depending on the speed, the sewing
foot pressure can be adjusted at
different speeds by the software.
On/Off
(see  p. 128)
121