Dürkopp Adler 878-M PREMIUM Operating Instructions Manual page 125

Operating Instructions 878-M PREMIUM - 06.0 - 11/2021
6.7.5.1 Setting the Bobbin monitor mode parameters
The amount of remaining thread on the bobbin can be monitored
optically or by software using this setting.
Menu item
Off
Monitor
Monitor mode can
only be used if the
additional equipment
of the remaining
thread monitor is
present on the
machine. Monitor
mode allows for
optical monitoring of
the bobbin.
Setting 1
Sewing stop
Sewing stops and a notice is
shown on the display when
the bobbin is detected to be
nearly empty. If the parameter
is not activated, only the
LEDs on the machine arm
give a warning if the bobbin is
empty.
Sewing foot lower
position
t Clean
Duration for which the lens is
blown clear with compressed
air. The process takes place
as the thread is cut.
Setting 2
Value range
On/Off
Value range
On/Off
Value range
0000–5000 [ms]
123