Internal Hard Disk Unit Installation Positions And Order - Fujitsu PRIMERGY RX300 S2 User Manual

Chapter 7 Installing Internal Options
7.6.1 Internal Hard Disk Unit Installation Positions and
Order
Install internal hard disk units in 3.5-inch storage bays in the front of the server.
When the server is installed with an internal backup device, you can install up to three internal hard disk
units.
Bay6
Bay5
Bay4
■ Installation Order
Install the internal hard disk units and internal backup devices in the 3.5-inch storage bays in the
following order.
State of 3.5-inch storage bay
When installed as standard
With internal backup devices
■ SCSI-ID Setting
SCSI-ID setting is not required for the 3.5-inch storage bay.
These 3.5-inch storage bays use hot plugs. A Single Connector Attachment2 (SCA2) connector is used
as an interface with an internal hard disk unit. This bay is equipped with power and signal cables as one
body; therefore, you need perform no troublesome cable connection.
202
table: Order of Internal Hard Disk Unit Installation
Bay 1 → Bay 4 → Bay 2 → Bay 5 → Bay 3 → Bay 6
Bay 1 → Bay 2 → Bay 3
Bay3
Bay2
Bay1
Installation order