Rompilot Submenu - Fujitsu PRIMERGY RX300 S2 User Manual

Chapter 8 Hardware Configuration/Utilities

8.2.16 RomPilot Submenu

Appears when [RomPilot] is selected from the [Server] menu.
This server cannot use this.
RomPilot Support:
Info
F1
Exit
Esc
Item
RomPilot Support
Reset on lost connection
Connect Timeout
NIC Slot No.
Server Menu
Local IP address
248
PhoenixBIOS Setup Utility
Server
RomPilot
[Disabled]
-/+ Change Values
Select Item
Select Menu Enter Select
table: Items on the RomPilot Submenu
Setting
Disabled (Fixed parameter)
• Disabled
• Enabled (at the time of
purchase)
• Low (at the time of
purchase)
• Medium
• High
3 (Fixed parameter)
-
-
Item Specific Help
F9 Setup Defaults
Sub-Menu F7 Previous Values
Description
Sets whether or not to use RomPilot.
Sets whether or not to reset the server a few seconds
after it was disconnected from the remote console.
This item appears when [RomPilot Support] is set
to [Enabled].
Sets the wait time taken to try a connection from
RomPilot to Front Ends 0 to 2 in sequence when
two or more management terminals are specified in
Front End 0 to 2 IP.
If no connection is established in the set time, an
attempt is made to connect to the next Front End.
This item appears when [RomPilot Support] is set
to [Enabled].
Sets the slot number of a LAN card found by
RomPilot.
This item appears when [RomPilot Support] is set
to [Enabled].
Sets the name of a unique server used in RomPilot.
This item appears when [RomPilot Support] is set
to [Enabled].
Specifies the IP address of the onboard LAN.
Specifying the IP address reflects the same value as
[Local IP address] in the IPMI submenu from the
[Advanced] menu.
This item appears when [RomPilot Support] is set
to [Enabled].