Fujitsu PRIMERGY RX300 S2 User Manual page 45

2
Check the MAC address.
Start up the server from the network.
The MAC address is displayed as shown below.
CLIENT MAC ADDR: XX XX XX XX XX XX
The MAC address is required for remote installation. Write it down.
You can turn the power on from a client (via a LAN) by utilizing the Wakeup on LAN (WOL) function.
Refer to "5.5.5 Turning the Power On via a LAN" ( pg.152).
Be sure to install ServerView to control the power supply via a LAN.
PRIMERGY RX300 S2 User's Guide
2
45